Installed a new oxygen sensor.
Materials:
- 140cm x 50cm 3mm MDF
- 140cm x 50cm Padding
- 140cm x 50cm Carpet
Equipment
- Stanley knife
- Metal ruler
- 25mm hole punch
Drawing up the template.
Cutting out the new board.
Shelf board finished
Padding adhered.
Test fitment.
Carpet added
Final fitting.
One week to get as much done on the MZ12 as I possibly can.
Goals:
- All electric cabling, cleaned, tested and installed
- All brake lines installed
- All engine coolant lines and radiator installed
- All underhood electric components cleaned and installed
- All underdash electrical components tested and installed, including fuse boxes
- Underdash AC and Heater units rebuilt and installed
- Side mirrors installed
- Roof header installed
- Carpet and rear seats installed
- Window trim installed
- Windscreen wipers, horn and washers work
- Driveshaft installed
- Install exhaust
- Fuel tank rebuilt and installed
- Fill engine with oil
Stretch Goals:
- Engine turns over for first time
- Bumper bars rebuilt and installed
- Windscreens, front and rear installed
- Rear lights installed
- Dashboard completely rebuilt and installed
- External trim installed
Days Plan:
- Cleaning Day - Soda blast everything, and paint any brackets or miscellaneous pieces.
- Wiring day - Check and clean all the wiring, rebuild the engine harness with new connectors
- Fetch day - Get as many necessary spare parts from the MZ11 as I can
Got around to rebuilding and installing the power steering pump this weekend.
Power window motor cleaned
Power Window Motor Installed
Starting state. Everything pretty rusty.
Phosphoric acid tube
Phosphoric acid tube
One week later, nice and clean. With old rust part for comparison.
After painting everything gets put back together
New hardware
Almost done,
Finished product!
Need to give this circut new capacitors to get the speakers to work again.
How to remove the rear windscreen wiper.
This is the rear windscreen wiper as it appears.
Pop the cap on the base of the wiper arm with a small screwdriver. Underneath, there is a nut which be removed with a 10mm ring spanner.
Remove the housing that recesses into the window with a pair of long nose pliers. The arm will pop off when this housing has been raised high enough.
The end result.