- Make and install heat shield for the TRUST header.
- Install the Raptor Racing intake.
- Install the battery isolation switch.
- Figure out the fuel level sender issues (is it back to working now?).
- Fix the bonnet, so it sits flush and also so that the windscreen washers fire properly.
- Fix the fitment of the drivers side fender so it doesn't rub when the driver's door is opened and closed.
- Figure out why the door control solenoid is acting up (is it that the switch in the drivers side door is not working, or is it just the wrong unit?)
- Install the rear speakers.
- Install new P/S rack and pump.
- Redo all the suspension (is it possible to recondition the TEMS inserts?).
- Redo all brake components (rotors and calipers).
- Figure out why the EMV only works intermittently.
- Get the air conditioner regassed.
- Rebuild the drivers side door card.
- Figure out and install the fog lights (how do they turn on?).
- Install rear windscreen and headlight washers.
- Get the rear FRP bump stops painted.
- New fluids.
- Install any missing rubber seals and electrical cable conduits.
MZ11GTL
MZ12GTL From: The Highway Star Garage
MZ11 From: http://exchange.goo-net.com/usedcars/TOYOTA/SOARER/700020495220110427002/index.html
Cluster disassembled for cleaning.
Reassembling all the different layers.
Completed!
Cluster installed in the dash.
Fitting all the plugs into the fascia before installing it.
Lining everything up.
Finished!
The side mirrors on the MZ12 are a bit of pain. They were only ever made for xZ1x soarers, and then only the ones that didn't come with fender mirrors.
There are lots of potential points of failure for these mirrors.
There are a lot of similarities between rebuilding a car, and doing the dishes.
Soaking in wool wash and simple green.
The best thing for cleaning before reassembling is Plexus plastic cleaner.
Main battery wiring all in place.
Underdash passenger side wiring in place.
Underdash driver's side wiring all in place.
Had to scrap the MZ11. But took time to remove everything from it before letting it go.
Rear TEMS
Front TEMS
A scan showing the dimensions of a MZ12.
Basic Dimensions:
Width: 1695mm
Length: 4675mm
Wheel Base: 2660mm
